ACI A/AN-PBS : Plastic Flush Mount Button Temperature Sensor, 10K Type III Thermistor, 24"Etched Teflon Leads
The ACI Thermistor Flush Mount Button Sensors Series features a stainless steel, brass or white plastic button sensor with two, 24 inch 22 AWG Etched Teflon colored lead wires to differentiate the different sensor types. The sensors in this series are manufactured using ACI’s proven encapsulation process to eliminate the effects of moisture upon the sensors and to increase the response times using our high quality, thermally conductive epoxy. This sensor uses a small, low profile design, and should be used in applications where aesthetics is your primary concern. Each unit is supplied with a mounting kit such that they can be hidden underneath cabinets or shelving units, in decorative metal plates, trim, drywall or from a 1⁄2” piece of conduit coming down from the ceiling or roof.
Specifications:
Sensor Type | Sensor Curve: | Thermistor | Non-Linear, NTC (Negative Temperature Coefficient) |
Number Sensing Points: | One |
Number Wires: | Two (Non-Polarity Sensitive) |
Sensor Output @ 25ºC (77ºF): |
|
Enclosure Material: |
|
Lead Length | Conductor Size: | 24” (61cm) | 22 AWG (0.65mm) |
Lead Wire Insulation | Wire Rating: | Etched Teflon (PTFE) Colored Leads | Mil Spec 16878/4 Type E) |
Datasheets
ACI Thermistors Flush Mount Buttons Data Sheet | |
ACI Thermistors Flush Mount Buttons Installation Sheet |
- Sensor Type:
- Flush Mount Button
- Temperature Element:
- 10K Type III
- Supported Protocols:
- None
- Humidity Element:
- None
- CO2 Element:
- None
- Setpoint:
- No Setpoint
- Override:
- No Override
- Display:
- No Display
- Material:
- Plastic