ACI A/1K-NI-PBS : Plastic Flush Mount Button Temperature Sensor, 1K Nickel RTD, 24"Etched Teflon Leads, Made in USA, 5-Year Warranty
The ACI Nickel Flush Mount Button Series features a stainless steel, brass or white plastic button sensor with two, 24 inch 22 AWG Etched Teflon colored lead wires to differentiate the different sensor types. The sensors in this series are manufactured using ACI’s proven encapsulation process to eliminate the effects of moisture on the sensors and to increase the thermal response time using our high quality, thermally conductive epoxy. This sensor uses a small, low profile design and should be used in applications where aesthetics is one of your primary concerns. Each unit is supplied with a mounting kit such that they can be hidden underneath cabinets or shelving units, in decorative metal plates, trim, drywall or from a 1⁄2” piece of conduit coming down from the ceiling or roof. Note that if painting the sensors, be sure to coat with aslittle paint as possible so as to not limit the effect on the accuracy or responsiveness of the sensor.
Specifications:
| Sensor Type | Sensor Curve: | Nickel RTD | PTC (Positive Temperature Coefficient) |
| Number Sensing Points: | One |
| Number Wires: | Two (Non-Polarity Sensitive) |
| Sensor Output @ 21.1ºC (70ºF): | 1000 Ohms Nominal |
| Enclosure Material: |
|
| Lead Length | Conductor Size: | 24” (61cm) | 22 AWG (0.65mm) |
| Lead Wire Insulation | Wire Rating: | Etched Teflon (PTFE) Colored Leads | Mil Spec 16878/4 Type E) |
Datasheets
 | ACI Nickel RTD Flush Mount Buttons Data Sheet |
| ACI Nickel RTD Flush Mount Buttons Installation Sheet |
- Sensor Type:
- Flush Mount Button
- Temperature Element:
- 1K Nickel RTD
- Supported Protocols:
- None
- Humidity Element:
- None
- CO2 Element:
- None
- Setpoint:
- No Setpoint
- Override:
- No Override
- Display:
- No Display
- Material:
- Stainless Steel
