The AimSafety 70-2900-0532-3 is the bump test and calibration hood for the PM400 series four-gas portable monitor. It seals over the sensor face so calibration gas can be applied at a controlled flow.
Specifications on this page are taken from the Macurco AimSafety product data workbook and the AimSafety documentation cited below.
Key Features
Technical Specifications
| Part Number | 70-2900-0532-3 |
|---|---|
| Description | PM400 bump / calibration hood |
| Compatible Monitors | AimSafety PM400-IR and PM400-P |
| Sold As | Each |
| Country of Origin | South Korea |
|---|---|
| ECCN | EAR99 |
Documentation
Related Products
Frequently Asked Questions
What is the AimSafety 70-2900-0532-3 used for?
It is the bump test and calibration hood for the PM400 series. It seals over the monitor sensor face so calibration gas can be applied during a bump test or span calibration.
Which monitors does this hood fit?
The PM400 series, covering both the PM400-IR and PM400-P. The PM100 and PM150 use a different hood, part number 70-2900-0531-1.
What else is needed to bump test a PM400 with this hood?
A calibration gas cylinder matched to the installed sensors, a fixed-flow regulator and calibration tubing. The PM400 quad mixture cylinder, part 37-0551-3344-2, supplies CO 100 ppm, H2S 25 ppm, CH4 50 % LEL and O2 18 % Vol.
- Product Type:
- Calibration Accessory
- Accessory Type:
- Calibration Hood
- Compatible Series:
- PM400
- Sold As:
- Each
